I finished the legs, and started running wires on the new extension. While reviewing my track plan with accessories, I realized that the control panel that I had planned for the side of the table really needed to be on the end of the next table. This is because the accessories require accurate car positioning, which could not be made looking from the side. Therefore, I had to extend the wires I had already run. I did realize that it is much easier to run wires from the top of the table, instead of underneath the table. The problem is now that I feel I should put a clear acrylic top on it instead of plywood, so people can see how much work goes on UNDER the layout.
I also started the small extension on the mainline table, where the light house will be located. The cardboard and blue papers are where the bay will be located.
View from one end showing wires and lights and new module
View from other end, showing more wire and bay
Side view of bay, module, and approximate track positions.
No comments:
Post a Comment